Thursday, 2 December 2010

How to use a Clay Bar?

So many people ask this question and there are lots of opinions on How to Clay Bar your Vehicle.

"That’s why we are going to tell you how we do it."

There is no hard and fast rule as all clay bars are different, some need a clay lube others just need water. There are different grades of clay bar so we always recommend a Versatile Clay such as SmartClay.

All products are personal preference and we can only advise on the products we are familiar with and use. However this guide is applicable to all Clay bars and Clay Lubes.

  •  Firstly it is important that you remove any loose contamination before you begin. So wash your vehicle with your preferred shampoo using the Two bucket method. There is no need to dry your vehicle however you can if you wish.   
  • Now your vehicle is FREE from any loose contamination you can check for bonded contamination. Do this by putting your hand into a plastic sandwich bag (zippy bag) and with the back of your hand gently glide across the bodywork. Any bonded contamination will pull or snag on the bag.
  •  It is always better to Clay bar your vehicle out of direct sunlight as if a panel is hot it can affect the lubricant in the products. You only need enough Clay to cover the palm of your hand and it does not need to be really thick between 3-5mm in depth will be plenty. The Clay will need to be softened you can do this by either kneading it in your hand or putting it in some warm water. When the Clay is soft and workable flatten it out in the palm of your hand. 
  • Depending on your Clay bar you will need to either spray Clay lube or Water onto a 2 foot square area of the panel. With the Clay Bar apply just enough pressure to allow the clay and the lubricant to glide across the surface. In a back and forth motion the clay and the lubricant will gently pull the bonded contamination from the paintwork. As the clay bar removes the contamination this process becomes very easy and the clay will freely glide across the panel.
  • If the Clay bar is sticking or gripping onto the paintwork you are applying to much pressure or you have not used enough lubricant. Stop, amend the problem and then continue. If you can hear the clay during this process it means the clay has collected to much contamination. Keep checking the surface of the clay you do not want to rub the collected contamination into the paintwork as this will cause marring.
  • Never kneed the Clay Bar back into itself, as this will allow the collected contamination to be scratched back into your paintwork. Once you have used both sides of the clay throw it away and get a new piece. Once the Clay bar glides across the paintwork with ease and your are satisfied with the results you can move on. Another way to see if you have removed the contamination is to put your hand in a sandwich bag and with the back of your hand gently pass over the panel. If the bag pulls or snags then there is still bonded contamination on the panel.
  • This is not a 5 minute job so make sure you have a few hours to spare. It may be a long process but it will be worth it in the end. Remember polish will remove surface contamination and dirt but a Clay bar is the only way to remove bonded contamination.

Once you have completed the Clay bar process you will need to polish and protect your paintwork.  A good quality wax or sealant will protect your vehicle from most road and traffic contamination. It will not stop particles from bonding to your paintwork but will decrease the amount of contamination on your vehicle.

The products we use can be found here..